DIY Parts and accessories for Classic Mustangs, Jaguar IRS, and Hydraulic clutches
Check out the free tech on my YouTube channel

60-66 UCA drop template

60-66 UCA Drop Template

  $18.00  +  $9.50 S&H

Orders that are canceled will be refunded less the 3-6% fee that PayPal no longer returns when a refund is issued.

Back to Parts List Page

This is a steel templates for doing the UCA drop on both 1964 & 1/2 through 1966 Mustangs, and also on early Falcons. This templates is made of 1/16" plate steel and is CNC cut for accuracy.  It bolts into the shock tower in the stock A-arm location and allows you to drill two pilot holes in the improved suspension location.  The template is then removed and the pilot holes can then be enlarged to accept the UCA bolts.

If you are ordering this template for a car other than a Mustang, before ordering please measure the distance between the UCA studs on your car.  A 3.75" measurement requires the 64-66 template and a 4.75" measurement requires the 67-70 template.

In order to properly perform the UCA drop a 17/32" drill bit is required to correctly size the new holes.  This bits can be hard to find locally and often times they are expensive.  If you need a bit I sell them individually or they can be purchased with a template as a "kit".  Please see "suggested parts" below if you ate needing a 17/32" drill bit

Only one template is needed as you use the same template to drill the pilot holes on both sides.

International Shipping Available.  Email me for additional cost information

Suggested Parts




 
New and reproduction parts
    If you need to order replacement reproduction parts for your Mustang make sure you check out Steve's Mustang Parts.







© 2013 DazeCars
The words / logos for Ford, Jaguar, Mustang, Galaxie, etc are used for descriptive and reference purposes only. DazeCars is neither affiliated with Jaguar Land Rover North America LLC, Ford Motor Company nor the manufacturers/distributors of Ford or Jaguar automobiles.